SilverCaterpillar296

[email protected]

?>

2025-01-18 07:51:03

Saturn ultra 4: how screwed am I?

Soaking the surface in IPA for a while and then scraping works best - for the LCD, just placing some drops along its surface, without letting it to drip inside, should be sufficient. Keep adding drops as old ones dry up for at least few minutes. This should help to reduce adhesion of the cured resin to the other surface. Then you can try scraping.

1737254081
Good tips thanks

1737256008
You may need to open the unit and really check inside. I image if the uv light was shining during this process so it’s most likely going to be partially cured.

1737188500
Yeah I popped the front off, it appears so, problem for tmro

1737188577